Follow the directions in the Camera Lens Calibration wizard.Mount the calibration image to something stiff and flat, such as cardboard, foam board, wood, or a clipboard.In the "Laser Tools" menu, open the "Camera Lens Calibration" wizard.Make sure the bed of your laser has good, consistent lighting and the camera is in focus.If your laser has a honeycomb bed or other surface with a lot of visible circles, you should cover it with something to block that pattern.Download and print the following image: Calibration-Circles.png.You can scale the image up or down when printing it, as well as raising or lowering the image to adjust how much of the camera view it takes up. You want the image to take up about 1/3 of your camera view. Older versions of this guide gave a specific size for the calibration image, but that will vary based on the size of your work area and the height of your camera. About 1/3 of the size of the camera's viewing area, when viewed through the camera.surrounded by a 6mm (1/4") or larger margin.In order to work properly, the calibration image must be:
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |